Le vernissage robotique entièrement automatique des composants complexes avec la technologie ATENSOR LS1*
Robot programmes are created offline for parts that need to be painted. In the process, the parts fixed to hangers are identified by automationCONTROL LPS 8005.T, and their position is determined. The corresponding robot programme is then called up and the component's position and orientation are automatically adjusted. Finally, the modified programme is run by the painting robot.
Individual robotic painting for objects on the hanger
Objects are detected automatically and correctly processed
Processing quality in every position is optimized by specialists
For new components, painting by robots with standard parameters is possible
Object sizes from 0.1 m to 10 m
Optimized cycle times by means of special algorithms
Other applications supported: cleaning, sand-blasting
*ATENSOR LS1 technology = robotic process automation for products with a high number of versions, which makes manual robot programming impossible. With the ATENSOR-LS1 (LS1 = lot size 1), robot programmes are dynamically generated on the basis of measurements. The programmes are then loaded and run in the robot memory.
By scanning in a scanning cabin, the location and geometry of the objects to be processed can be recorded digitally. On the basis of this data, the robot programme is adapted by the system to each object, and then processing is performed by the processing robot. The process is carried out automatically, without any manual intervention.
100% non-contact measurement
Resolution less than 1 mm
Hangers and mounts are omitted from the processing